WARNING: The policy configuration for the active policy has changed because of addition/deletion/modification of rule(s). Sw0:FID128:admin> mapsrule -create monitor_ALL_16GSWL_SFPTXP_251 -monitor TXP -group ALL_16GSWL_SFP -value 251 -op LE -qt 86400 -action SFP_MARGINAL,RASLOG -policy monitor_sfp_error_policy_1_0 Mapsrule -create monitor_ALL_16GSWL_SFPTXP_251 -monitor TXP -group ALL_16GSWL_SFP -value 251 -op LE -qt 86400 -action SFP_MARGINAL,RASLOG -policy Mapsrule -delete monitor_ALL_16GSWL_SFPTXP_251Įnter the new rule for 16G optics to add it to the current active policy, and set the rule to trigger only once in a 24-hour period so that it does not fill up the RASlog: In case the new rule is already present, delete it so we do not try and make duplicate rules: Verify that the actions have been added to Configured Notifications:Ĭonfigured Notifications: RASLOG,SW_CRITICAL,SW_MARGINAL,SFP_MARGINAL Mapsconfig -action SW_CRITICAL,SW_MARGINAL,RASLOG,SFP_MARGINAL If RASLOG or SFP_MARGINAL are not part of Configured Notifications, add these actions. RASLOG and SFP_MARGINAL Configured Notifications check: Verify current configured actions and make note of Configured Notifications."Ĭonfigured Notifications: SW_CRITICAL,SW_MARGINAL Mapspolicy -enable monitor_sfp_error_policy_1_0 Mapspolicy -clone dflt_moderate_policy -name monitor_sfp_error_policy_1_0Įnable the newly cloned policy, currently only a copy of previously enabled policy.
Sw0:FID128:admin> mapspolicy -show -summaryĬlone the current active policy that is used to add the new rules to the clone being made.
On a system that has the Fabric Vision License installed, the following are commands with explanation as to what the command is setting up:ĭetermine the policies in use and which is active: If a MAP trigger is logged once this rule is created, the optic should be replaced as soon as possible to avoid it degrading worse and possibly causing link errors.
These define a threshold trigger, and a series of reporting actions. The two new rules to apply to the MAPS configuration are defined below. KB 77898: Connectrix B-Series: Network performance degradation reported due to low transmit (Tx) power levels in 32G SWL optics, TSB 2019-274-A.įor a complete understanding, the user should reference the document, Brocade Fabric OS MAPS User Guide, 8.2.1x, FOS-821-MAPS-UG102.
KB 77893: Connectrix B-Series: Optic laser failure or low transmit (Tx) power levels in certain 16G SWL optics, TSB 2019-276-A.Upon receipt of the alert message, the Administrator moves to the second part of the monitoring process to run the approved actions as outlined in the following KB articles:.This flags any optic encountered on the switch that has crossed the alert threshold. When a rule triggers, messages and alerts to the Administrator is generated. For each of the TSBs 274-A and 276-A, a new rule must be added. MAPS has been supported since Fabric OS 7.4.0. This can be accomplished by adding a couple of new rules to the Monitoring and Alerting Policy Suite (MAPS) configuration.